Converter Accessory: Contents

                                                 

About Us Products News Resource Center Customer Service Contact Us Register/Log In

Home >>> Tech Tip

Are you adding slitting to an existing process?

Are you considering modifying or replacing existing slitting equipment? If you are, it is always a good idea to send samples to your potential slitting equipment supplier.

Generally speaking, slitting equipment suppliers have some amount of testing equipment at their facility. They can run your samples (even if it is just hand feeding them into a slitter) which will help to determine the best slitting solution for your web and process.

When sending samples to a supplier make sure to send samples of all of the webs you will potentially run in your process. The slitting equipment supplier may recommend one or more slitting methods base solely on the samples they have in hand.

Be very careful of selecting a slitting system for which samples have not been tested.





**DISCLAIMER - A great deal of time has been invested in the development of our weekly tech tips. To the best of our knowledge, they are accurate. It is up to the user to verify all results.

THE AUTHOR ASSUMES NO LIABILITY CONNECTED WITH THE USE OF THIS INFORMATION OR THE RESULTS OBTAINED FROM IT.



Converter Accessory Corporation
201 Alpha Road
P.O. Box 188
Wind Gap PA 18091-0188

Phone (800) 433-2413 or (610) 863-6008
Fax (800) 709-1007 or (610) 863-7818

sales@converteraccessory.com

www.converteraccessory.com


      
What is Web Handling?
Web Handling is the science, engineering and equipment necessary to successfully transport a continuous flexible material through various processes without defect. Enhancing Web Handling with proper equipment will ensure materials are processed at their maximum efficiency, allowing the process to generate maximum profits.

**Click here for CAC's terms and conditions**


RETURN TO TOP